![]() ![]() If it did not complete, or resulted in Error, see the Special Notes below.ĭrive-by-Wire (DBW) Engines using KWP-7000 (UDS/ODX)Ĭheck to see if the engine speaks KWP-2000 or CAN by looking in the top left of the Open Controller Screen. It should now say "Basic Settings: OFF" on the top of your screen Leave it in Basic Settings for about 30 seconds. You will see the values change and hear the TB cycle for the first few seconds then it will stop. The TB adaptation is being done as soon as you switched basic settings on. Once you do this you will see the top right display say ADP RUN. It should now say "Basic Settings: ON" on the top of your screen. It should say "Basic Settings: OFF" on the top of your screen. Some examples of CAN engine controllers are the Mk5 Golf 2.0T FSI) An example of a KWP-2000 engine controller is the 2002+ B6 Audi A4 1.8T. Check to see if the engine speaks KWP-2000 or CAN by looking in the top left of the Open Controller Screen. (These are engines WITHOUT a physical cable between the accelerator and the throttle. button and you're all set.ĭrive-by-Wire (DBW) Engines using KWP-2000 or CAN.Check to see if the engine speaks KW-1281 by looking in the top left of the Open Controller Screen Some examples of KW-1281 engine controllers are 2000+ Golf/GTI/Jetta/New Beetle/Audi TT 1.8T) Click the button and you're all set.īe sure not to touch the accelerator and make sure the engine is NOT running when you do this!ĭrive-by-Wire (DBW) Engines using KW-1281. ![]() The TB adaptation is being done as soon as you switch to basic settings. Turn the key on but do not start the car.Įnter Group 098 (Note: Some SIMOS or Marelli ECU's use Group 001 such as ADY & AEE engines) (These are engines with a physical cable between the accelerator and the throttle, but WITHOUT an ISV.)
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |